Cisco Firepower 4110 Hardware Installation Guide

Figure 2: Firepower 4100 Package Contents
Blue console cable PC terminal adapter2Firepower 4100 chassis1
10/100/1000BASE-T SFP transceiver4Two power cords (country-specific)
See Power Cord Specifications, on page 32 for
a list of supported power cords.
3
Tie wrap clamp6Two slide rails5
Flextronics tie wrap8Artesyn tie wrap7
Ten 8-32 x 0.375 inch Phillips screws used to
secure the mounting bracket to chassis (six
screws), and the cable management brackets to
the mounting brackets (four screws)
10Two M3 x 6 mm screws used to secure the inner
slide rail to the chassis
9
Two 10-32 x 0.375 inch screws used to secure
the ground lug
12Two slide rail locking brackets11
Two cable management brackets14One ground lug #6 AWG, 90 degree, #10 post13
Cisco Firepower 4100
This document has a URL pointing to the
hardware installation guide, a URL pointing the
regulatory and safety guide, and a QR code and
URL pointing to the Getting Started Guide.
15
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
5
Overview
Package Contents

Cisco Firepower 4110 Specifications

General

Power Supply	Dual, hot-swappable
Form Factor	1RU
Firewall Throughput (Multiprotocol)	10 Gbps
Number of 10GE (SFP+) Interfaces	8
Number of 40GE (QSFP+) Interfaces	2
Redundant Power Supply	Yes
Memory	32 GB
Ports	8 x 10GE, 2 x 40GE
Concurrent Sessions	8 Million
Number of 10/100/1000 Interfaces	8
Maximum Connections	8 Million
Management Ports	1 x RJ45
Data Ports	8 x 10GE, 2 x 40GE
Processor	Intel Xeon E5-2600