Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
11) Specify an optional password for the certificate request:
Firepower-chassis /security/keyring/certreq# set password password
12) Specify the state or province in which the company requesting the certificate is headquartered:
Firepower-chassis /security/keyring/certreq# set state state
13) Specify the fully qualified domain name of the FXOS chassis:
Firepower-chassis /security/keyring/certreq# set subject-name subject-name
14) Commit the transaction:
Firepower-chassis /security/keyring/certreq# commit-buffer
15) Display the certificate request, which you can copy and send to a trust anchor or certificate authority:
Firepower-chassis /security/keyring/certreq# show certreq
4.5.6.4 Creating a Trust Point
1) Enter services mode:
Firepower-chassis# scope security
2) Create a trust point:
Firepower-chassis /security# create trustpoint name
3) Specify certificate information for this trust point:
Firepower-chassis /security/trustpoint# set certchain [ certchain ]
4) Commit the transaction:
Firepower-chassis /security/trustpoint# commit-buffer
4.5.6.5 Importing a Certificate into a Key Ring
1) Enter services mode:
Firepower-chassis# scope security
2) Enter configuration mode for the key ring that will receive the certificate:
Firepower-chassis /security# scope keyring keyring-name
3) Specify the trust point for the trust anchor or certificate authority from which the key ring certificate
was obtained:
Firepower-chassis /security/keyring# set trustpoint name
To Next Page
Loading...
Need help?
General
