EasyManuals Logo

Cisco Firepower 4110 User Manual

Cisco Firepower 4110
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
4.5 Management Functions
4.5.1 IP Management and Pre-Login Banner
Changing the Management IP Address
You can change the management IP address on the FXOS chassis from the FXOS CLI.
1) Connect to the FXOS CLI.
2) To configure an IPv4 management IP address:
a) Set the scope for fabric-interconnect a:
Firepower-chassis# scope fabric-interconnect a
b) To view the current management IP address, enter the following command:
Firepower-chassis /fabric-interconnect # show
c) Enter the following command to configure a new management IP address and gateway:
Firepower-chassis /fabric-interconnect # set out-of-band ip ip_address
netmask network_mask gw gateway_ip_address
d) Commit the transaction to the system configuration:
Firepower-chassis /fabric-interconnect* # commit-buffer
3) To configure an IPv6 management IP address:
a) Set the scope for fabric-interconnect a:
Firepower-chassis# scope fabric-interconnect a
b) Set the scope for management IPv6 configuration:
Firepower-chassis /fabric-interconnect # scope ipv6-config
c) To view the current management IPv6 address, enter the following command:
Firepower-chassis /fabric-interconnect/ipv6-config # show ipv6-if
d) Enter the following command to configure a new management IP address and gateway:
Firepower-chassis /fabric-interconnect/ipv6-config # set out-of-band
ipv6 ipv6_address ipv6-prefix prefix_length ipv6-gw gateway_address
e) Commit the transaction to the system configuration:
Firepower-chassis /fabric-interconnect/ipv6-config* # commit-buffer

Table of Contents

Other manuals for Cisco Firepower 4110

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 4110 and is the answer not in the manual?

Cisco Firepower 4110 Specifications

General IconGeneral
Power SupplyDual, hot-swappable
Form Factor1RU
Firewall Throughput (Multiprotocol)10 Gbps
Number of 10GE (SFP+) Interfaces8
Number of 40GE (QSFP+) Interfaces2
Redundant Power SupplyYes
Memory32 GB
Ports8 x 10GE, 2 x 40GE
Concurrent Sessions8 Million
Number of 10/100/1000 Interfaces8
Maximum Connections8 Million
Management Ports1 x RJ45
Data Ports8 x 10GE, 2 x 40GE
ProcessorIntel Xeon E5-2600

Related product manuals