Configuring AAA Services on Cisco IOS XR Software
How to Configure AAA Services
SC-219
Cisco IOS XR System Security Configuration Guide
DETAILED STEPS
Command or Action Purpose
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2
line {aux | console | default | template
template-name
}
Example:
RP/0/RP0/CPU0:router(config)# line console
Enters line template configuration mode.
• For more information on configuring line templates,
see Implementing Physical and Virtual Terminals on
Cisco IOS XR Software.
Step 3
accounting {commands | exec} {default |
list-name
}
Example:
RP/0/RP0/CPU0:router(config-line)# accounting
commands listname7
Enables AAA accounting for a specific line or group of
lines.
• The commands keyword enables accounting on the
selected lines for all EXEC shell commands.
• The exec keyword enables accounting for an interactive
(EXEC) session.
• Enter the default keyword to apply the name of the
default method list, as defined with the aaa accounting
command.
• Enter the name of a list of accounting methods to use.
If no list name is specified, the system uses the default.
The list is created with the aaa accounting command.
• The example enables command accounting using the
method list named listname7.
Step 4
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-line)# end
or
RP/0/RP0/CPU0:router(config-line)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
–
Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
To Next Page
Loading...
Need help?
General
