9600 baud
•
•
8 data bits
•
No parity
•
1 stop bit
•
No flow control
Step 5
When connected, press enter or type en to access the command prompt.
Entering en prompts you for a password, and then enters privileged exec mode. The default password is Cisco and is
case-sensitive.
When you finish configuring the access point:
Step 6
Use a small flat-blade screwdriver to depress the tab on the RJ45 connector and disconnect the cable from the CON port.
Step 7
Replace the CON port cover.
Step 8
Use a 0.5 in. (13 mm) socket wrench to torque the CON port cover to 6-7 ft-lbs (8.13-9.49 N-m).
53
To Next Page
Loading...
