Cisco LightStream 1010

18 LightStream 1010 ATM Switch Processor Module Configuration Note
Configuring the Interfaces
You can identify module ports by physically checking the card/subcard/port location on the front of
the switch. You can also use software commands to display information about a specific interface,
or all interfaces, in the switch. To display information about every interface, use the show interface
command without parameters. To display information about a specific interface, use the show
interface command with the interface type and port address in the format show interface atm
card/subcard/port. This command is described in the LightStream 1010 ATM Switch Command
Reference publication.