Doc. No.
Cisco Systems, Inc.
All rights reserved.
LightStream 1010 ATM Switch Processor Module
Configuration Note
78-2988-01 Rev. A0
Product Numbers: WATM-ASP1=
This document contains instructions for installing and configuring the LightStream 1010 ATM
switch processor (ASP) module. For a complete description of commands used to configure and
maintain the ASP, refer to the LightStream 1010 ATM Switch Software Configuration Guide and
LightStream 1010 ATM Switch Command Reference publications. For complete hardware
configuration and maintenance procedures, refer to the LightStream 1010 ATM Switch User Guide
publication.
Cisco documentation and additional literature are available on a CD called Cisco Connection
Documentation, Enterprise Series. The CD is updated and shipped monthly, so it might be more
up-to-date than the printed documentation. To order the Cisco Connection Documentation,
Enterprise Series CD, contact your local sales representative or call Customer Service. The CD is
available both as a single CD and as an annual subscription. You can access Cisco technical
documentation on the World Wide Web Universal Resources Locator (URL)
http://www.cisco.com.
Sections in this document include the following:
• What is the LightStream 1010 ATM Switch?
• ASP Description
• ASP LEDs
• Preparing Network Connections
• Safety Recommendations
• Installing and Replacing the ASP
• Configuring the Interfaces
• ASP Configuration Defaults
Warning Only trained and qualified personnel should install or replace the LightStream 1010 ATM
switch, chassis, power supplies, fan assembly, or modules.
To Next Page
Need help?
General