Cisco Linksys SGE2010P

SGE2010/SGE2010P Administration Guide 24
System Configuration
Using the Console
Show Certificate
Use the Show Certificate screen to display the internal certificate.
To open this screen:
1. From the Sw
itch Main Menu, select 1. System Configuration.
2. From the Sy
stem Configuration Menu, select 4. Security Settings.
3. From the Sec
urity Settings Menu, select 2. SSL Show Certificate.
4. When you finish using this screen, select Quit.
Disable Active Management Access Profile
You can use select option 3 on the Security Settings menu to disable the active management
access profile.
To disable the active management access profile:
1. From the S
w
itch Main Menu, select 1. System Configuration.
2. From the Sy
stem Configuration menu, select 4. Security Settings.
3. From the Sec
urity Settings Menu, select 3. Disable Active Management Access Profile.
4. When the confirmation message appears, press Y to
confirm, or press N to cancel.
Country Name Specifies the country name. (Range: 2 to 2)
Validity Term Specifies number of days certification is valid. (Range: 30 to
3650)