Cisco Linksys SGE2010P

SGE2010/SGE2010P Administration Guide 31
System Configuration
Using the Console
IPv6 Address Table
The IPv6 Address Table lists the IPv6 addresses that are configured.
To open this screen:
1. From the S
w
itch Main Menu, select 1. System Configuration.
2. From the Sy
stem Configuration Menu, select 6. IP Configuration.
3. From the IP
Configuration menu, select 2. IPv6 Address Configuration.
4. From the IP
v6 Address Configuration menu, select 3. IPv6 Address Table.
IPv6 ISATAP Enable
You can use the IPv6 I
SATAP Enable screen to configure the ISATAP tunnel.
To open this screen:
1. From the Sw
itch Main Menu, select 1. System Configuration.
2. From the Sy
stem Configuration Menu, select 6. IP Configuration.
3. From the IP
Configuration menu, select 2. IPv6 Address Configuration.
4. From the IP
v6 Address Configuration menu, select 4. IPv6 ISATAP Enable.