SGE2010/SGE2010P Administration Guide 38
System Configuration
Using the Console
TraceRoute IPv4
You can use the Tra
ceRoute IPv4 screen to run a trace route test for an IPv4 address
To open the screen:
1. From the Sw
itch Main Menu, select 1. System Configuration.
2. From the Sy
stem Configuration Menu, select 6. IP Configuration.
3. From the IP
Configuration menu, select 5. Network Configuration.
4. From the Network C
onfiguration menu, select 3. Trace Router IPv4.
To change the IP address:
1. Select Ed
i
t, and then enter the IPv4 address.
2. Press the Esc ke
y to move the cursor to the Action list.
To begin the trace route test:
1. Select Ex
ec
ute to begin the test.
2. After the test is complete, the results of the test appear on the screen.
3. When the Oper
ation complete message appears, press the Esc key to move the cursor to the
Action list.
To Next Page
Loading...
Need help?
General
