18
Chapter 4: Configuring the PrintServer Using the Setup Wizard
Installing the PrintServer
Wireless-G PrintServer
20. The next screen will indicate that the setup of the PrintServer is complete. Now you will need to install the
driver. Click Next to install the driver. The installation will occur automatically. Then proceed to the
Configuration of the PrintServer Driver section of “Chapter 5: Windows Driver Installation”.
If you have additional computers on your network, insert the Setup CD-ROM into the next computer and select
Set up Computer on the Welcome screen. Then proceed to “Chapter 5: Windows Driver Installation”.
If you want to make a change, click Back. If you want to exit the Setup Wizard, click Exit.
Figure 4-21: Installation of PrintServer Driver
To Next Page
Loading...
Need help?
General