APPENDIX A
Cable and Port Specifications
This appendix includes information about the cables and connectors used with this switch.
We strongly recommend that power cable runs and other potential noise sources be located as far away
as practical from network cabling that terminates at Cisco equipment. In situations where long parallel
cable runs exist, but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these
potential noise sources. To avoid interference, the source should be shielded by housing it in a grounded
metallic conduit.
Caution
• Cables and Adapters, on page 47
• Console Port, on page 48
• Out of Band Ethernet Management Port, on page 49
• Supported Power Cords and Plugs, on page 51
Cables and Adapters
The accessory kit includes the following:
• RJ-45-to-RJ-45 rollover cable
• RJ-45-to-DB-9 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 male DCE adapter (labeled Modem)
Additional cables and adapters can be ordered from your customer service representative.
Note
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
If you purchased this product directly from Cisco, contact Cisco Technical Support at
http://www.cisco.com/c/en/us/support/index.html.
Note
Cisco MDS 9124V-K9 Switch Hardware Installation Guide
47
To Next Page
Loading...
