If you do not order a power cord with the system, you are responsible for selecting the appropriate power
cord for the product. Using a noncompatible power cord with this product may result in electrical safety
hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered
with the system.
Caution
Standard Power Cords
Cisco standard power cords for the switch, have an IEC C15 connector on the outlet end of the cord, and a
country specific plug on the inlet end of the cord.
The following table lists the supported power cords and power plugs for the switch.
Table 13: Supported Power Cords and Power Plugs
Power Plug Reference
Illustration
LengthSource Plug
Type
Power Cord Part
Number
Locale
8.2 ft (2.5 m)IRAM 2073 plug
(10 A)
CAB-9K10A-ARArgentina
8.2 ft (2.5 m)SAA/3 plug, AS
3112-1993 (10
A)
CAB-9K10A-AUAustralia
8.2 ft (2.5 m)GB1002 (10A)CAB-9K10A-CHChina
8.2 ft (2.5 m)VIIG Plug, CEE
(7) VII (16 A)
CAB-9K10A-EUEurope
14 ft (4.27 m)SI 32 Part 1.01
(16A)
CAB-9K10A-ISRIsrael
8.2 ft (2.5 m)1/3G plug, CEI
23-16 (10 A)
CAB-9K10A-ITItaly
8.2 ft (2.5 m)CEE 7 Standard
Sheet VII (16A)
CAB-9K10A-KORKorea
Cisco MDS 9124V-K9 Switch Hardware Installation Guide
52
Cable and Port Specifications
Standard Power Cords
To Next Page
Loading...
