Cisco MDS 9000 Series - Jumper Power Cords

Power Plug Reference
Illustration
LengthSource Plug
Type
Power Cord Part
Number
Locale
5.12 ft (1.82 m)EL 208, SABS
164-1 (10 A)
CAB-9K10A-SASouth Africa
8.2 ft (2.5 m)12G SEV 1011
(10 A)
CAB-9K10A-SWSwitzerland
13.12 ft (4 m)CNS 10917-2 &
CNS 690 (15A)
CAB-9K10A-TWNTaiwan
8.2 ft (2.5 m)BS89/13, BS
1363/A
(13 A;
replaceable fuse)
CAB-9K10A-UKUnited Kingdom
8.2 ft (2.5 m)NEMA 5-15P
plug (15 A)
CAB-9K12A-NANorth America
7 ft (2.13 m)NBR 14136
(10A)
CAB-250V-10A-BRBrazil
Jumper Power Cords
Jumper power cords have an IEC C15 connector on the outlet end of the cord and an IEC C14 connector on
the inlet end of the cord. This cord is compatible with IEC C13 outlet receptacles. This type of outlet receptacle
is commonly used for power distribution inside cabinets.
The following table lists the supported jumper power cords and power plugs for the switch.
Table 14: Supported Jumper Power Cords
IllustrationLengthPlug TypeDescription
6.6 ft (2.0 m)IEC C14 (250 VAC 10
A)
CAB-C13-C14-2M
Cisco MDS 9124V-K9 Switch Hardware Installation Guide
53
Cable and Port Specifications
Jumper Power Cords