Configure H.323 and SIP
(When not set by a provisioning system)
To get online and ready to place and receive calls, your
system must be set up properly. Your system uses either the
H.323 protocol or the SIP protocol for video calls.
NOTE: Contact your system administrator, or service provider,
for information about the network settings.
For networks administered through Cisco TMS (TelePresence
Management Suite), your Cisco TMS administrator will help
you to get online.
You can find information about administering through Cisco
UCM in the Administering CE endpoints on CUCM guide.
H.323
If in doubt about any of the parameters below, contact your
system administrator or your service provider.
1.
Tap the gearwheel icon in the upper left corner and tap
Settings > Administrator > H323.
2.
Enter the H323 Number and H323 Id in their respective
input fields.
3.
Enter the Gatekeeper Address in the corresponding input
field.
4. If the H.323 gatekeeper requires authentication and you
want your system to authenticate itself to the gatekeeper,
tap ON in the Authentication Mode section and enter the
Login Name and Password in their respective input fields.
Otherwise, tap OFF.
5.
Tap Save to confirm the changes, or Undo to leave
without saving.
6.
Review the System Information page and verify the H323
settings.
If you have successfully registered to the Gatekeeper,
the Status is shown as Registered in the H323 section.
7. Tap Exit to return to the home menu.
SIP
If in doubt about any of the parameters below, contact your
system administrator or your service provider.
1.
Tap the gearwheel icon in the upper left corner and tap
Settings > Administrator > SIP.
2. Enter the SIP URI in the URI input field.
3.
Tap the preferred transport protocol in the Default
Transport section. If you select Auto, the system tries
first to connect using TLS, then TCP, and finally UDP.
4.
Select a Proxy Type by tapping - or +. The default type is
Standard. You can use Cisco when registering to CUCM.
5.
Enter the Proxy Address in the corresponding input field.
6.
If the SIP proxy server requires authentication, you must
enter the Login Name and Password in their respective
input fields to authenticate your system.
7.
Tap Save to confirm the changes, or Undo to leave
without saving.
8.
Review the System Information page and verify the SIP
settings.
If you have successfully registered to a SIP server, the
Status is shown as Registered in the SIP section.
9. Tap Exit to return to the home menu.
Cisco TelePresence Video Systems
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016. Copyright © 2016 Cisco Systems, Inc. All rights reserved. 28
Getting Started Guide
On-screen setup assistant
To Next Page
Loading...
Need help?
General
