Date, time and location
(When not set by a provisioning system)
We recommend you check that the date and time settings
are correct when you set up your video conference system.
The system uses this information for example to time stamp
messages transmitted to gatekeepers and other network
elements.
You can find the time in the top right corner of the Touch
controller display.
1.
Tap the user name in the upper left corner and tap
Settings > Administrator > Date, Time & Location.
2. Tap 24h or 12h to select the Time Format you prefer.
3. Tap dd.mm.yy, mm.dd.yy or yy.mm.dd to select the Date
Format you prefer.
4.
Select the Time Zone Area and Time Zone Location for
your system. Step through the list of available zones by
tapping - or + .
5.
Set Date & Time Mode to Auto if you want time and date
to be automatically updated; otherwise, select Manual.
a.
If you select Manual, enter the correct value for
Hour, Minute, Year, Month, and Day. Tap - and + to
decrease or increase a value.
b.
If you select Auto, the NTP server address can be
automatically obtained from the network (set the
NTP Mode to Auto) or you can enter the NTP Server
address yourself (set NTP Mode to Manual).
6.
Tap Save to confirm the changes, or Undo to leave
without saving.
7. Tap Exit to return to the home menu.
Cisco TelePresence Video Systems
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016. Copyright © 2016 Cisco Systems, Inc. All rights reserved. 29
Getting Started Guide
On-screen setup assistant
To Next Page
Loading...
Need help?
General
