Cisco NCS 4200 Series - Page 8

Device# show mpls l2 vc
Local intf Local circuit Dest address VC ID Status
------------- -------------------------- --------------- ---------- ----------
CE0/0/8 CEM 20 2.2.2.2 3000 UP
CE0/0/8 CEM 21 2.2.2.2 3001 UP
CE0/0/8 CEM 22 2.2.2.2 3002 UP
Verifying VCoP Smart SFP Configuration for STS-3C on OC-3
Use the show controller command to verify the VCoP smart SFP configuration.
Device#show controller sonet 0/0/10
SONET 0/0/10 is up.
Hardware is 12xGE-4x10GE-FIXED
Port configured rate: OC-3
Applique type is Channelized Sonet/SDH
Clock Source is Line
Medium info:
Type: Sonet, Line Coding: NRZ,
SECTION:
LOS = 0 LOF = 0 BIP(B1) = 0
SONET/SDH Section Tables
INTERVAL CV ES SES SEFS
15:58-16:11 0 0 0 0
LINE:
AIS = 0 RDI = 0 REI = 0 BIP(B2) = 0
Active Defects: None
Detected Alarms: None
Asserted/Active Alarms: None
Alarm reporting enabled for: SLOS SLOF SF B1-TCA B2-TCA
BER thresholds: SF = 10e-3 SD = 10e-6
TCA thresholds: B1 = 10e-6 B2 = 10e-6
Rx: S1S0 = 40
K1 = 00, K2 = 00
J0 = 01
RX S1 = 00
Tx: S1S0 = 00
K1 = 00, K2 = 00
J0 = 01
SONET/SDH Line Tables
INTERVAL CV ES SES UAS
15:58-16:11 0 0 0 0
High Order Path:
PATH 1:
AIS = 0 RDI = 0 REI = 0 BIP(B3) = 0
LOP = 0 PSE = 0 NSE = 0 NEWPTR = 0
LOM = 0 PLM = 0 UNEQ = 0
Active Defects: None
Detected Alarms: None
Asserted/Active Alarms: None
Alarm reporting enabled for: PLOP LOM B3-TCA
TCA threshold: B3 = 10e-6
Rx: C2 = 00
Tx: C2 = 00
PATH TRACE BUFFER : UNSTABLE
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
8