Figure 63: Unlocking a Fabric Card from its Slot in the Chassis
Rotate both ejector handles away from the front of
the fabric card.
2Unscrew two captive screws (one on each ejector
handle).
1
b) Rotate the two handles at least 30 degrees so that the other end of each handle no longer holds the module in the slot
(see Callout 2 in the previous figure).
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of the slot (see
the following figure).
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
113
Replace Chassis Components
Removing a Fabric Card
To Next Page
Loading...
