EasyManuals Logo

Cisco NCS1004 User Manual

Cisco NCS1004
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Bandwidth : 200.0Gb/s
Alarm Information:
LOS = 0 LOF = 1 LOM = 0
OOF = 0 OOM = 0 AIS = 0
IAE = 0 BIAE = 0 SF_BER = 0
SD_BER = 0 BDI = 3 TIM = 0
FECMISMATCH = 0 FEC-UNC = 0
Detected Alarms : None
Bit Error Rate Information
PREFEC BER : 0.00E+00
POSTFEC BER : 0.00E+00
Q-Factor : 16.70 dB
Q-Margin : 0.99dB
TTI :
Remote hostname : ios
Remote interface : CoherentDSP 0/0/0/0
Remote IP addr : 0.0.0.0
FEC mode : Soft-Decision 27
AINS Soak : None
AINS Timer : 0h, 0m
AINS remaining time : 0 seconds
Configuring Loopback on OTN-XP Card
From R7.2.1 onwards, OTN-XP card supports loopback on the OTU2, OTU2e, OTU4, 10GE, and CoherentDSP
controllers.
The CoherentDSP controller supports both line and internal.
To configure the loopback on the controllers, use the following commands.
configure
controller controllertype Rack/Slot/Instance/Port/Lanenumber
sec-admin-state maintenance
loopback [ line | internal ]
commit
The range of Lanenumber is from 1 to 4.
The following is a sample in which the internal loopback is configured on the 10GE controller.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller tenGigECtrlr 0/0/0/5/2
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#sec-admin-state maintenance
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#loopback internal
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#commit
RP/0/RP0/CPU0:ios#show controllers tenGigECtrlr 0/0/0/5/2
Thu Apr 23 10:47:48.020 UTC
Operational data for interface TenGigECtrlr0/0/0/5/2:
State:
Administrative state: enabled
Operational state: Up
Configuring Controllers
34
Configuring Controllers
Loopback

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS1004 and is the answer not in the manual?

Cisco NCS1004 Specifications

General IconGeneral
BrandCisco
ModelNCS1004
CategoryNetwork Hardware
LanguageEnglish

Related product manuals