Cisco Network Device Cisco 2800 User Manual

9
Troubleshooting Cisco 2800 Series Routers
OL-5789-01
System Messages
— — Error:
%ENVMON-3-FAN_FAILED: Fan fan-number not rotating.
Explanation:
The specified fan (1, 2, or 3) is not rotating at the desired speed.
Recovery:
Make sure that the fan power cable is properly attached to the mainboard fan power connector.
If the problem persists, contact your technical support representative.
AUX/
PWR
Amber Message:
%ENVMON-5-48V_STATUS: -48V supply failed
Explanation:
The –48 V power supply has failed.
Recommended action:
Replace the power supply. Refer to the “Replacing the Power Supply” section of the “Installing
and Upgrading Internal Modules in Cisco 2800 Series Routers” online document.
AUX/
PWR
Green Message:
%ENVMON-5-48V_STATUS: -48V supply OK
Explanation:
The –48 V power supply is operating normally.
Recommended action:
Message is informational only.
— — Message:
%ENVMON-5-RPS: Redundant power supply attached
Explanation:
Redundant power supply was connected to the router.
Recommended action:
Message is informational only.
Note The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
— — Message:
%ENVMON-5-RPS: Redundant power supply removed
Explanation:
Redundant power supply was disconnected from the router.
Recommended action:
Message is informational only.
Note The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
Table 3 System Error and Recovery Messages (continued)
LED Type LED Color Message, Meaning, and Recommended Action

Cisco Network Device Cisco 2800 Specifications

General

Brand	Cisco
Model	Network Device Cisco 2800
Category	Network Router
Language	English