D14908.02 SX20 Administrator Guide TC6.0, JANUARY 2013. www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
107
Cisco TelePresence SX20 Quick Set Administrator Guide
Microphone 1 (3.5 mm mini-jack)
2 × USB (for future use)
Camera input (custom)
PC video input (DVI-I input)
Main monitor (HDMI 1 output)
Second monitor (HDMI 2 output)
Power Kensington lock
Power socket
Always use the provided Lite-On PA-1600-2A-LF power
supply.
Output from the power adapter to the codec: 5 A, 12 V
Input to the power adapter: 2 A, 100-240 V, 50-60 Hz
Loudspeaker (line-out)
3.5 mm mini-jack, 3-conductor connector. To be used with
active speakers (built-in amplifier) only.
PC audio input (line-in)
3.5 mm mini-jack, 3-conductor connector. Used when
connecting to a PC or other external playback devices, such
as a DVD player.
Microphone 1 and 2
3.5 mm mini-jack, 4-conductor connector. To be used with
the Cisco Table Microphone 20 only.
2 × USB
For future use. Also for serial communication via RS-232
adapter.
Network connector
Ethernet interface, 1 × 10 Mb / 100 Mb / 1 Gb Ethernet LAN
interface (RJ45).
PC video input
DVI-I socket, digital/analog video input for PC presentations.
Monitor outputs (main and second)
HDMI socket, digital video and audio output for the main
monitor; digital video output for the second monitor.
Camera input, combined HDMI and camera control
The custom camera socket consists of an HDMI connector
for digital video input from the camera, and a connector for
camera control and power.
The VISCA™* protocol for camera control (pan, tilt, zoom) is
supported. Pin no. 20 provides 12 V DC / 1.5 A to the main
camera.
Kensington lock
The Kensington lock may be used to prevent the codec from
being moved or to prevent theft.
*VISCA™ is a trademark of Sony Corporation
Rear panel
The connectors used in a basic setup are highlighted in blue.
Microphone 2 (3.5 mm mini-jack)
Loudspeaker (3.5 mm mini-jack)
PC audio input (3.5 mm mini-jack)
Network (RJ45)
To Next Page
Loading...
Need help?
General
