setting of the device.
In order to disable this feature, complete these steps:
Click the User 1 or User 2 tab.1.
Set VMWI Ring Splash Len to 0.2.
Q. I cannot access the voice menu when I press ****. What should I do?
A. Complete these steps:
Unplug your Ethernet cable.1.
Try to go into the IVR again.2.
If it is successful, this indicates a misconfiguration on your network settings.3.
Make sure that you have the correct DNS and gateway IP address.4.
Q. I lost the web password for my SPA device. How do I reset it?
A. In order to reset your SPA device to the factory default values, complete these steps.
Unplug your Ethernet cable.1.
Press **** in order to access the voice menu.2.
Press 73738#.3.
Login with the username user when you access http://spa-ip-address.4.
Login with admin when you access http://spa-ip-address/admin/. Note: If you reset your
device, it erases all your current configuration settings. If your SPA device is provisioned by a
service provider, the reset function can be password protected. In this case, contact your
service provider.
5.
Q. How do I enable the Admin web access (http) from the phone?
A. Complete these steps:
From the IVR (voice menu), press 723646#.1.
Press 1 in order to enable web admin access. 0, or No on the web, is the default and
disables it.
2.
Q. How do I enable access to the SPA2102 Web Interface?
A. Complete these steps:
Use the analog phone and press ****.1.
From the IVR (voice menu), press 7932#.2.
In order to enable this feature, press 1 and 1 again.3.
Q. How do I enable access to the SPA3102 Web Interface?
A. Complete these steps:
To Next Page
Loading...
Need help?
General
