Use the analog phone and press ****.1.
From the IVR (voice menu), press 7932#.2.
In order to enable this feature, press 1. Now you can access the web server configuration
screens. Note: You can press 110 in order to learn your IP address.
3.
Q. Can I have IVR options for network settings without the DHCP server?
DHCP— 101#, 0=disable, 1=enable
●
IP Address—111# to set, 110# to check
●
Netmask—121#
●
Gateway—131#
●
Primary DNS—161# to set, 160# to check
●
Q. How do I troubleshoot the upgrade utility for my SPA Device?
A. Complete these steps:
Run the upgrade utility from the computer.1.
The embedded upgrade file is sent through port 69, 70, or 71 and so on, if available.2.
The upgrade begins when the SPA device is not in use.3.
If the upgrade hangs at ...Firmware upload will begin only when SPA is idle, verify: The
phone is properly hung up on both lines.Any firewall software, such as Internet Connection
Firewall, is disabled on your PC.The PC and SPA device are on the same LAN subnet. The
upgrade does not work if your PC is behind a wireless router and your SPA device is in front
of the router.
4.
Q. How can I set the Internet access for my SPA device behind a router with
NAT?
A. Configure your router to forward TCP port 80 to the IP address that is currently used by the
SPA device. If you do this often, use a static IP address on the SPA device, instead of DHCP. For
help with port forwarding, consult the manual of your router.
In order to access the web page of the SPA device from outside, connect to the external IP
address of your router. In order to determine the external IP address of your router, you must be in
your home network and check the WAN address of your router.
Q. How can I obtain the password for my locked SPA device? What are the
available alternatives?
Option 1—You can reset the password with the steps in answer four. If you reset your unit, it
erases all the configuration settings, and the device reverts to factory defaults.
●
Option 2—We recommend that you contact your service provider or request the password
from whoever provided the device.
●
Q. My SPA device is behind a router that uses NAT. I can call by IP and the
other unit rings, but there is no voice. How do I resolve this problem?
To Next Page
Loading...
Need help?
General
