Phone.com Setup and Troubleshooting Guide
Cisco SPA301 1-Line IP Phone
5 / 8 Revised: 30 October 2012
Call Blocking (cont.)
Anonymous calls cannot be blocked. To block callers with hidden caller ID, refer to the “Numbers” section
of your Phone.com Control Panel.
If you blocked a number by mistake:
● Dial [*][9] again if you are still on the call. You will hear: “This caller has been unblocked.”
● Or, visit the Call Logs section in your Phone.com Control Panel, then click “Call Blocking
Settings.”
Call Recording
As a Phone.com user, you have the ability to record incoming calls. However, please check your current
state and the other party’s state and Federal laws before using this feature.
● Dial [*][7] to start recording. You will hear: “Recording is now on.”
● Dial [*][7] again to stop recording. You will hear: “Recording is now off.”
To Next Page
Loading...
