Cisco TelePresence MX200 G2 Administrator's Guide

D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
135
Cisco TelePresence MX700 and MX800 Administrator Guide
Factory resetting Touch 10
1. Locate the Mute and Volume down buttons.
2. Press and hold the Mute button until it starts blinking (red
and green). It takes approximately 10 seconds.
3. Press the Volume down button twice.
Touch 10 automatically reverts to the default factory
settings and restarts.
Mute
Volume down
Factory resetting the Touch 10
user interface
In an error situation it may be required to factory reset
the Touch 10 user interface to recover connectivity. This
should be done only when in contact with the Cisco support
organization.
When factory resetting Touch 10 the pairing information is
lost, and the Touch itself (not the video system) is reverted to
factory defaults.
It is not possible to undo a factory reset.
Contents
Introduction
Web interface
System settings
Setting passwords
AppendicesAppendices

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30