Cisco TelePresence MX200 G2 Administrator's Guide

D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
43
Cisco TelePresence MX700 and MX800 Administrator Guide
Setting strong security mode
Strong security mode should be used only when compliance
with DoD JITC regulations is required.
Read the provided information carefully before setting
strong security mode.
Strong security mode sets very strict password requirements,
and requires all users to change their password on the next
sign in.
Software upload from TMS, web snapshots and calling from
the web interface are prohibited in strong security mode.
Setting strong security mode
Read carefully about the consequences of
strong security mode before you continue.
1. If you want to use strong security mode,
click Enable strong security mode....
Confirm your choice in the dialog box
that appears.
The system will restart automatically.
2. Change the password when you are
prompted. The new password must meet
the strict criteria as described.
How to change the system password is
described in the ► Setting passwords
section.
Return to normal mode
When in strong security mode, the system
can be restored to normal mode by clicking
Disable strong security mode.... Confirm your
choice in the dialog box that appears
The system will restart automatically.
Navigate to: Configuration > Security: Strong Security Mode tab
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
Web interface

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30