Name: Cisco TelePresence MX200 G2
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Cisco TelePresence MX700 and MX800 Administrator Guide

GPIO settings

GPIO Pin [1..4] Mode

The four GPIO pins are configured individually. The state can be retrieved by "xStatus GPIO Pin

[1..4] State". The default pin state is High (+12 V). When activated as output, they are set to 0 V.

To activate them as input, they must be pulled down to 0 V.

Requires user role: ADMIN

Value space: <InputNoAction/OutputManualState/OutputInCall/OutputMicrophonesMuted/

OutputPresentationOn/OutputAllCallsEncrypted/OutputStandbyActive/InputMuteMicrophones>

InputNoAction: The pin state can be set, but no operation is performed.

OutputManualState: The pin state can be set by "xCommand GPIO ManualState Set PinX:

<High/Low>" (to +12 V or 0 V, respectively).

OutputInCall: The pin is activated when in call, deactivated when not in call.

OutputMicrophonesMuted: The pin is activated when microphones are muted, deactivated

when not muted.

OutputPresentationOn: The pin is activated when presentation is active, deactivated when

presentation is not active.

OutputAllCallsEncrypted: The pin is activated when all calls are encrypted, deactivated when

one or more calls are not encrypted.

OutputStandbyActive: The pin is activated when the system is in standby mode, deactivated

when no longer in standby.

InputMuteMicrophones: When the pin is activated (0 V), the microphones will be muted.

When deactivated (+ 12 V), the microphones are unmuted.

Example:

GPIO Pin 1 Mode: InputNoAction

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices

System settings

Other manuals for Cisco TelePresence MX200 G2

Questions and Answers:

Need help?

Do you have a question about the Cisco TelePresence MX200 G2 and is the answer not in the manual?

General