Cisco Telepresence MX200 - Sharing Content

D14850.12 MX200 and MX300 Administrator Guide TC7.3, JULY 2015. www.cisco.com — Copyright © 2011–2015 Cisco Systems, Inc. All rights reserved.
17
Cisco TelePresence MX200 and MX300 Administrator Guide
Navigate to: Call Control
Sharing content
You can connect a presentation source to one of the external
inputs of your video system. Most often a PC is used as
presentation source, but other options may be available
depending on your system setup.
While in a call you can share content with the other
participant in the call (far end).
If you are not in a call, the content is shared locally on your
display.
Sharing content
1. Choose a Presentation source from the
drop-down list.
2. Click Start Presentation.
Stop content sharing:
Click the Stop Presentation button that is present
while sharing.
Whether or not snapshots of input sources are shown as illustrated,
depends on the software version, configuration, and options installed
on the video system. Refer to the About snapshots and remote
monitoring sections (► TC7.3.3 or newer or ► TC7.3.0 to TC7.3.2).
Contents
Introduction
System settings
Setting passwords
Appendices
Web interfaceWeb interface