Cisco Telepresence MX200 - Local Layout Control

D14850.12 MX200 and MX300 Administrator Guide TC7.3, JULY 2015. www.cisco.com — Copyright © 2011–2015 Cisco Systems, Inc. All rights reserved.
20
Cisco TelePresence MX200 and MX300 Administrator Guide
Local layout control
You can choose a local layout using the Call Control page.
The term layout is used to describe the various ways the
videos from the conference participants and a presentation
can appear on the screen. Different types of meetings may
require different layouts.
Change the layout
Click Change layout, and choose
your preferred layout in the window
that opens.
The set of layouts to choose
from depends on the system
configurations.
You may change the layout while
in a call.
Navigate to: Call Control
Whether or not snapshots of input sources are shown as illustrated,
depends on the software version, configuration, and options installed
on the video system. Refer to the About snapshots and remote
monitoring sections (► TC7.3.3 or newer or ► TC7.3.0 to TC7.3.2).
Contents
Introduction
System settings
Setting passwords
Appendices
Web interfaceWeb interface