Type xConfiguration SystemUnit Password
Note: you cannot set a blank password for the admin user or any other administrator account, or the root
account.
Changing the root account password
To change the password for the root account:
1. Using a serial connection, log in as root using the existing password.
2. Type the command passwd.
You will be asked for the new password.
3. Enter the new password and when prompted, retype the password.
4. Type exit to log out of the root account.
Changing other system settings
You are also required to configure the following:
n The system name of the CiscoVCS. This is used by the Cisco TelePresence Management Suite (Cisco
TMS) to identify the system. This can be set from the System administration page (System
>Administration) on the web interface.
n Automatic discovery. If you have multiple CiscoVCSs in the same network you may want to disable
automatic discovery on some of them. This can be set from the H.323 page on the web interface
(Configuration > Protocols>H.323).
n The DNS server address(es), if URI dialing or Fully Qualified Domain Names (FQDNs) are to be used. This
can be set from the DNS page on the web interface (System > DNS).
See the online help or CiscoTelePresence VideoCommunicationServer Administrator Guide for more
information on these configuration options.
Checking for updates and upgrading
To check whether your CiscoVCS has the latest software installed go to
http://software.cisco.com/download/navigator.html and navigate to the CiscoVCS.
See CiscoTelePresence VideoCommunicationServer Administrator Guide for information on how to
upgrade.
Note: you must not downgrade to a software version lower than X8.1.1.
Cisco TelePresence VCSCE500 Appliance Installation Guide (8.5) Page 11 of 16
Configuring
To Next Page
Loading...
Need help?
General
