Contents
iv
Cisco UCS C22 Server Installation and Service Guide
OL-26646-01
Server Configuration Utility 3-1
Status LEDs and Buttons 3-2
Front Panel LEDs 3-2
Rear Panel LEDs and Buttons 3-4
Preparing for Server Component Installation 3-6
Required Equipment 3-6
Shutting Down and Powering Off the Server 3-6
Removing and Replacing the Server Top Cover 3-7
Removing and Replacing the Front Chassis Panel 3-8
Replaceable Component Locations 3-9
Serial Number Location 3-9
Installing or Replacing Server Components 3-10
Replacing Hard Drives or Solid State Drives 3-11
Drive Population Guidelines 3-11
Drive Replacement Procedure 3-11
Replacing a Front Operations Panel Board 3-12
Replacing a Drive Backplane 3-14
Replacing Fan Modules 3-16
Replacing DIMMs 3-17
Memory Performance Guidelines and Population Rules 3-18
DIMM Replacement Procedure 3-21
Replacing CPUs and Heatsinks 3-22
Replacing the Motherboard RTC Battery 3-27
Replacing a PCIe Riser 3-28
Replacing a PCIe Card 3-30
PCIe Slots 3-30
Replacing a PCIe Card 3-31
Special Considerations for Cisco UCS Virtual Interface Cards 3-32
RAID Controller Card Cable Routing 3-32
Replacing a Cisco USB Flash Drive 3-33
Overview of the Pre-Loaded 16-GB Cisco USB Flash Drive 3-33
Enabling a Pre-Loaded Cisco USB Flash Drive Virtual Drive 3-33
Booting a Pre-Loaded Cisco USB Flash Drive Virtual Drive 3-34
Monitoring and Managing a Cisco USB Flash Drive 3-35
Cisco USB Flash Drive Replacement Procedure 3-35
Enabling or Disabling the Internal USB Port 3-36
Replacing the SuperCap Power Module (RAID Backup Unit) 3-37
Installing a Trusted Platform Module 3-39
Enabling the Intel Trusted Execution Technology (TXT) Feature For the TPM 3-40
To Next Page
Loading...
