Cisco UCS S3260 Service Manual

3-32
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
Chapter 3 Maintaining the System
Installing or Replacing System Components
The adapter and host reset. The activated firmware becomes the running version.
Using the Cisco IMC PMCLI Interface to Update SIOC Adapter Firmware
Step 1 Update and activate the adapter firmware by using the following commands:
Server# scope chassis
Server/chassis# update-adapter-fw <protocol> <remote server IP address> <image file path>
<activate|no-activate> [SIOC slot number]
For example:
server1/chassis# update-adapter-fw tftp nnn.nnn.nnn.nnn /fw-image.bin activate 1
Adapter firmware update has started. Please check the status using "show adapter detail".
You have chosen to automatically activate the new firmware image. Please reset your
adapter after the update finishes.
Step 2 Reset the adapter:
Note You must reset the adapter to make the activated firmware version the running version. Resetting
the adapter also causes the host to reset.
server/chassis# adapter-reset <SIOC1 or SIOC2>
For example:
server/chassis# adapter-reset SIOC1
The adapter and host reset. The activated firmware becomes the running version.

Cisco UCS S3260 Specifications

General

Drive Bays	Up to 56
Maximum Storage Capacity	Up to 600 TB
Power Supply	Up to 4 hot-plug power supplies
Product Type	Storage Server Chassis
Supported Drives	SAS, SATA
Processors	Up to two Intel Xeon Scalable processors
Memory	Up to 1.5 TB DDR4 RAM
Power Supplies	Redundant 80+ Platinum power supplies
Total Drive Bays	56
Management	Cisco UCS Manager
Compatibility	Cisco UCS system
Form Factor	4U rack