IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Related Documentation
See the latest release notes at Cisco IOS Release Notes for Cisco EnergyWise, EnergyWise Version 2.8 for
the following information:
•
For the list of devices that EnergyWise supports, see the "Supported Devices" section.
•
For Device Manager requirements, see the "System Requirements" section.
•
For upgrade information, see the "Downloading Software" section.
For information about the Cisco IOS Release commands, see the Cisco IOS documentation set on Cisco.com.
For initial configuration information, see the "Using Express Setup" section in the getting started guide or the
"Configuring the Switch with the CLI-Based Setup Program" appendix in the hardware installation guide.
For information about how to install your network device, see the hardware installation guide for your device.
For Network Assistant requirements, see Getting Started with Cisco Network Assistant (not orderable but
available on Cisco.com). This guide does not provide detailed information on the GUIs for embedded Device
Manager or for Cisco Network Assistant (hereafter referred to as Network Assistant), which you can use to
manage the domain member. However, the concepts in this guide are applicable for the GUI user. For
information about Device Manager, see the domain member online help.
For cluster requirements, see the release notes for Cisco Network Assistant (not orderable but available on
Cisco.com).
For information about the management application programming interface (MAPI) and endpoint software
development kit (SDK), go to the Cisco Developer Network.
Obtaining Documentation and Support on the Cisco Developer
Network
Cisco EnergyWise development partners can access the Cisco EnergyWise documents, MAPI and SDK
software code, and Cisco IOS software by joining the Cisco Developer Network:http://developer.cisco.com/
web/esdk/home
You need a support contract and license to access Cisco EnergyWise resources on the Cisco Developer Network
and on TAC. The business development manager who registered your licence must set up your Cisco.com
account with the appropriate access privileges.
Cisco EnergyWise Cisco IOS Command Reference for Catalyst 3850 Switches, EnergyWise Version 2.8
OL-32343-01 vii
Preface
Related Documentation
To Next Page
Loading...
Need help?
General