Cisco vEdge 1000 - Ports and Connectors

DescriptionvEdge5000
Router
vEdge
2000
Router
vEdge
1000
Router
Viptela Part
Number
Manufacturer & Part
Number
• SFP+ transceiver
• LC-type transceiver
• Short-reach 850-nm optics for
multi-mode fiber for dual-rate 1
Gbps/10 Gbps applications
Note : The SFP+ ports of the 10-Gigabit
Ethernet PIM support a rate of 10 Gbps
only. 1 Gbps is not supported.
XXFinisar
FTLX8571D3BCV
• SFP+ transceiver
• LC-type connector
• Long-reach 1310-nm optics for
single-mode fiber up to 10 km for
dual-rate 1 Gbps/10 Gbps applications
Note: The SFP+ ports on the 10-Gigabit
Ethernet PIM support a rate of 10 Gbps
only. 1 Gbps is not supported.
XXFinisar
FTLX1471D3BCV
• SFP+ transceiver
• LC-type connector
• Long-reach 1310-nm optics for
single-mode fiber up to 10 km for
10-Gbps applications
XXSFP+-10GE-LRFinisar
FTLX1471D3BCL
Ports and Connectors
The vEdge 2000 router supports three types of ports: network ports (also called SFP ports), management port,
and console port.
Network Ports (SFP Ports)
The built-in network ports on the vEdge 2000 router as well as the 8x1-Gigabit Ethernet SFP PIM module
support 1-Gbps SFP module. The 2x10-Gigabit Ethernet SFP+ PIM module supports 10-Gbps SFP+ module.
Table 1 provides the pinout information for the built-in SFP and the PIM SFP/SFP+ port connector. The
SFP/SFP+ ports comply with the SFP/SFP+ MSA standards.
Hardware Installation Guide for vEdge Routers
173
vEdge 2000 Router
Ports and Connectors