You can download the Windows driver here .
To use the USB console from a Macintosh device:
1. Install the USB serial drivers attached here .
2. Launch the Terminal utility.
3. From a terminal shell, access the console port with this command:
$ screen /dev/tty.usbserial* 115200,cs8
vEdge 100b Router Default Configuration
Default Configuration for Software Releases 16.1 and Later
For Releases 16.1 and later, the default configuration file looks like this:
vEdge100b# show running-config
system
vbond ztp.viptela.com
aaa
auth-order local radius tacacs
Hardware Installation Guide for vEdge Routers
43
vEdge 100b Router
vEdge 100b Router Default Configuration
To Next Page
Loading...
