Figure 7: Positioning the vEdge 2000 Router in the Rack
1. Have a second person secure the mounting ears to the front of the rack using four rack-mount screws (two
on each side) from the packet marked A. Tighten the screws.
Figure 8: Attaching the Short Mounting Ears to the Rack
1. Secure the 1U sliders to the rear post, using the remaining four rack-mount screws (two on each side) in
the packet marked A. Tighten the screws.
Figure 9: Attaching the 1U Sliders to the Rear of the Rack
Hardware Installation Guide for vEdge Routers
191
vEdge 2000 Router
Install the vEdge 2000 Router
To Next Page
Loading...
