QuantityComponent
1USB console cable
2Mounting ears, left and right
6Mounting-ear screws (Packet A)
4Rack-mount screws (Packet B)
1 + 4AC power adapter and connectors
1Quick Start document
Mount the vEdge 100b Router
You can mount the vEdge 100b router in one of the following ways:
• Mount the router in a 19-inch rack
• Mount the router on the wall
In addition to the accessory box, you need the following tools to mount a vEdge 100b router:
• Number 2 Phillips (+) screwdriver
• Tape measure or level
Mount the vEdge 100b Router in a Rack
You can mount the vEdge 100b router on two front posts in a 19-inch rack using simple rack mount ear
accessories. To do so:
1. Place the router chassis on the floor or on a sturdy table near the rack.
2. Verify the internal dimensions of the rack with a tape measure. The rack-mount tray is 440 mm wide and
must fit within the mounting posts.
3. Secure the left and right mounting ears to either side of the router chassis using the six screws (two on
each side) in the packet marked A.
Figure 2: Attaching the Mounting Ears to the vEdge 100b Router Chassis
1. Grasp both sides of the router, then lift and position it in the rack, making sure that the mounting ear holes
are aligned with the threaded holes in the rack rail.
Hardware Installation Guide for vEdge Routers
38
vEdge 100b Router
Install the vEdge 100b Router
To Next Page
Loading...
