4-3
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
OL-15959-01
Chapter 4 Powering On the Voice Gateway and Performing the Initial Configuration
Performing the Initial Configuration
Here are the Cisco IOS commands.
username <myuser> privilege 15 secret 0 <mypassword>
no username cisco
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about Cisco CP please follow the instructions in the QUICK START
GUIDE for your voice gateway...
...
User Access Verification
Username:
Step 3 Enter the username cisco, and press Return or Enter.
The system displays the following prompt:
Password:
Step 4 Enter the password cisco, and press Return or Enter.
The system displays the following prompt:
VG#
The system displays a message that is similar to the first warning message. The message directs you to
change the username and password.
You are now in privileged EXEC mode.
Note You must change the username and password before you log off the voice gateway. You cannot
use the username cisco or password cisco after you log off from this session.
Step 5 To change the username and password, enter the following at the prompt:
username username privilege 15 secret 0 password
Where username and password are the username and password that you wish to use.
Step 6 Use the copy running-config startup-config command at the privileged EXEC mode prompt (VG#) to
save the configuration to NVRAM.
Using the setup Command to Configure the Voice Gateway
Before You Begin
Perform the procedure in the “Using the Cisco IOS CLI to Configure the Voice Gateway” section on
page 4-2.
Procedure
Step 1 In privileged EXEC mode, at the prompt, enter setup.
yourname# setup
The system displays the following message:
--- System Configuration Dialog ---
To Next Page
Loading...
Need help?
General
