Cisco VG450 User Manual

Installing the Cisco VG450 Voice Gateway
While you do this installation, record your progress and site information. See the suggested format in the
Installation Checklist.
Tip
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Danger
Read the installation instructions before connecting the system to the power source. Statement 1004
This chapter contains the procedures for installing your Cisco VG450 Voice Gateway and consists of the
following sections:
Danger
• Safety Recommendations, on page 1
• Unpacking and Inspection, on page 5
• Install the Cisco VG450 Voice Gateway, on page 5
• Chassis Grounding, on page 10
• Power-On Procedure, on page 11
Safety Recommendations
The following information is included to alert you to safety recommendations and best practices when working
with this equipment.
Maintaining Safety with Electricity
Follow these guidelines when working on equipment powered by electricity.
High leakage current—earth connection essential before connecting to system power supply. Statement 342
Danger
Installing the Cisco VG450 Voice Gateway
1

Cisco VG450 Specifications

General

Power Supply	Internal AC power supply
Form Factor	1RU
Mounting	Rack-mountable
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Protocols	SIP, MGCP
Storage Temperature	-4°F to 149°F (-20°C to 65°C)
Network Interfaces	4 x 10/100/1000 Ethernet ports

Summary

Cisco VG450 Safety and Precautions

Safety Recommendations Overview

Key safety advice and best practices for working with the Cisco VG450 Voice Gateway.

Electrical Safety Guidelines

Procedures and warnings for safe operation with electricity and power systems.

General Safety Practices and Tips

Essential practices for personal safety, equipment protection, and emergency procedures.

Preventing Electrostatic Discharge Damage

Steps to protect sensitive electronic components from Electrostatic Discharge.

Cisco VG450 Installation and Mounting

Unpacking and Inspection Procedures

How to unpack the VG450, check components, and inspect for shipping damage.

Chassis Placement and Wall Mounting

Instructions for desktop placement and attaching the chassis to a wall.

Rack Mounting Instructions

Detailed steps for installing the VG450 chassis into standard EIA and SBC racks.

Cisco VG450 Grounding and Power

Chassis Grounding Connection

Procedure for connecting the equipment chassis to a reliable earth ground for safety.

Power-On and Initialization

Steps to power on the VG450 and verify its successful initialization and self-test.