Cisco WAP371 - Chapter 7: Client Quality of Service; Client Qos Global Settings; Acl

7
Cisco Small Business WAP371 Wireless Access Point Administration Guide 102
Client Quality of Service
This chapter provides an overview of Client quality of service (QoS) and explains the QoS
features available from the Client QoS menu. It contains these topics:
• Client QoS Global Settings
•ACL
• Class Map
• Policy Map
• Client QoS Association
• Client QoS Status
Client QoS Global Settings
You can use the Client QoS Global Settings page to enable or disable quality of service
functionality on the WAP device.
If you disable Client QoS Mode, all ACLs, rate limiting, and DiffServ configurations are
globally disabled.
If you enable this mode, you can also enable or disable Client QoS mode on particular VAPs.
See the Client QoS Mode setting on the Client QoS Association page.
ACL
ACLs are a collection of permit and deny conditions, called rules, that provide security by
blocking unauthorized users and allowing authorized users to access specific resources. ACLs
can block any unwarranted attempts to reach network resources.
The AP supports up to 50 IPv4, IPv6, and MAC ACLs.