Status and Statistics
Email Alert Status
Cisco Small Business WAP371 Wireless Access Point Administration Guide 21
2
Email Alert Status
The Email Alert Status page provides information about the email alerts sent based on the
syslog messages generated in the WAP device. To view the Email Alert Status page, select
Status and Statistics > Email Alert Status in the navigation pane.
• Email Alert Status—The Email Alert configured status. The status is either Enabled or
Disabled. The default is Disabled.
• Number of Emails Sent—The total number of emails sent. The range is an unsigned
integer of 32 bits. The default is 0.
• Number of Emails Failed—The total number of email failures. The range is an
unsigned integer of 32 bits. The default is 0.
• Time Last Email Sent—The day, date, and time when the last email was sent.
You can click Refresh to show the most current information.
Log
The Log page shows a list of system events that generated a log entry, such as login attempts
and configuration changes. The log is cleared upon a reboot and can be cleared by an
administrator. Up to 512 events can be shown. Older entries are removed from the list as
needed to make room for new events.
To view the Log page, select Status and Statistics > Log in the navigation pane.
• Time Stamp—The system time when the event occurred.
• Severity—Whether the event is due to an error (err) or is informational (info).
• Service—The software component associated with the event.
• Description—A description of the event.
You can click Refresh to refresh the screen and show the most current information.
You can click Clear All to clear all entries from the log.
To Next Page
Loading...
