Administration
User Accounts
Cisco Small Business WAP371 Wireless Access Point Administration Guide 23
3
To configure system settings:
STEP 1 Select Administration > System Settings in the navigation pane.
STEP 2 Enter the parameters:
• Host Name—Administratively assigned name for the WAP device. By convention, the
name is the fully qualified domain name of the node. The default host name is wap
concatenated with the last 6 hex digits of the MAC address of the WAP device. Host
Name labels can contain only letters, digits and hyphens. Host Name labels cannot
begin or end with a hyphen. No other symbols, punctuation characters, or blank spaces
are permitted. The Host Name can be 1 to 63 characters long.
• System Contact—A contact person for the WAP device. The System Contact can be 0
to 255 characters long and can include spaces and special characters.
• System Location—Description of the physical location of the WAP device. The System
Location can be 0 to 255 characters long and can include spaces and special characters.
STEP 3 Click Save. The changes are saved to the Startup Configuration.
User Accounts
One management user is configured on the WAP device by default:
• User Name: cisco
• Password: cisco
You can use the User Accounts page to configure up to four additional users and to change a
user password.
Adding a User
To add a new user:
STEP 1 Select Administration > User Accounts in the navigation pane.
The User Account Table shows the currently configured users. The user cisco is preconfigured
in the system to have Read/Write privileges.
All other users can have Read Only Access, but not Read/Write access.
STEP 2 Click Add. A new row of text boxes appears.
To Next Page
Loading...
