Administration
User Accounts
Cisco Small Business WAP371 Wireless Access Point Administration Guide 24
3
STEP 3 Check the box for the new user and select Edit.
STEP 4 Enter a User Name between 1 to 32 alphanumeric characters. Only numbers 0 to 9 and letters
a to z (upper or lower) are allowed for user names.
STEP 5 Enter a New Password between 1 and 64 characters and then enter the same password in the
Confirm New Password text box.
As you enter a password, the number and color of vertical bars changes to indicate the
password strength, as follows:
• Red—The password fails to meet the minimum complexity requirements.
• Orange—The password meets the minimum complexity requirements but the password
strength is weak.
• Green—The password is strong.
STEP 6 Click Save. The changes are saved to the Startup Configuration.
NOTE To delete a user, select the check box next to the user name and select Delete. To save your
deletion permanently, select Save when complete.
Changing a User Password
To change a user password:
STEP 1 Select Administration > User Accounts in the navigation pane.
The User Account Table shows the currently configured users. The user cisco is preconfigured
in the system to have Read/Write privileges. The password for the user cisco can be changed.
STEP 2 Select the user to configure and click Edit.
STEP 3 Enter a New Password between 1 and 64 characters and then enter the same password in the
Confirm New Password text box.
As you enter a password, the number and color of vertical bars changes to indicate the
password strength, as follows:
• Red—The password fails to meet the minimum complexity requirements.
• Orange—The password meets the minimum complexity requirements but the password
strength is weak.
• Green—The password is strong.
To Next Page
Loading...
