8
Cisco Small Business WAP371 Wireless Access Point Administration Guide 120
Simple Network Management Protocol
This chapter describes how to configure the Simple Network Management Protocol (SNMP)
to perform configuration and statistics gathering tasks.
It contains these topics:
• General SNMP Settings
•Views
•Groups
•Users
•Targets
General SNMP Settings
You can use the General page to enable SNMP and configure basic protocol settings.
To configure general SNMP settings:
STEP 1 Select SNMP > General in the navigation pane.
STEP 2 Select Enabled for the SNMP setting. SNMP is disabled by default.
STEP 3 Specify a UDP Port for SNMP traffic.
By default, an SNMP agent listens only to requests from port 161. However, you can
configure this so that the agent listens to requests on a different port. The valid range is from
1025 to 65535.
STEP 4 Configure the SNMPv2 settings:
• Read-only Community—A read-only community name for SNMPv2 access. The valid
range is 1 to 256 alphanumeric and special characters.
To Next Page
Loading...
