Single Point Setup
Wireless Neighborhood
Cisco Small Business WAP371 Wireless Access Point Administration Guide 156
10
• Dark Gray Bar—A dark gray bar and no signal strength number indicates the WAP
device itself that corresponds to the IP address listed above it. A signal strength of zero
is displayed because the device’s own signal strength is not measured.
Viewing Details for a Single Point Setup Member
To view details on a cluster member, click the IP address of a member at the top of the page.
The following details for the device appear below the Neighbors list.
• SSID—The Service Set Identifier for the neighboring access point.
• MAC Address—The MAC address of the neighboring access point.
• Channel—The channel on which the access point is currently broadcasting.
• Rate—The rate in megabits per second at which this access point is currently
transmitting. The current rate is always one of the rates shown in Supported Rates.
• Signal—The strength of the radio signal detected from the access point, measured in
decibels (dB).
• Beacon Interval—The beacon interval used by the access point.
• Beacon Age—The date and time of the last beacon received from this access point.
To Next Page
Loading...
