Cisco WAP371 - Completing the Setup Wizard; 7 Suggested Next Steps; Troubleshooting Connectivity

Getting Started
Using the Access Point Setup Wizard
Cisco Small Business WAP371 Wireless Access Point Administration Guide 5
1
The Wizard displays the Enable Captive Portal - Create Your Guest Network window.
STEP 17 Select whether or not to set up an authentication method for guests on your network, and click
Next.
If you click No, skip to STEP 25.
If you click Yes, the Wizard displays the Enable Captive Portal - Name Your Guest Network
window.
STEP 18 Specify a Guest Network Name for Radio 1. For the WAP371 device, select whether the guest
network uses Radio 1 or Radio 2.
STEP 19 Click Next. The Wizard displays the Enable Captive Portal - Secure Your Guest Network
window.
STEP 20 Choose a security encryption type for the guest network and enter a security key. For a
description of these options, see System Security.
STEP 21 Click Next. The Wizard displays the Enable Captive Portal - Assign the VLAN ID window.
STEP 22 Specify a VLAN ID for the guest network. The guest network VLAN ID should be different
from the management VLAN ID.
STEP 23 Click Next. The Wizard displays the Enable Captive Portal - Enable Redirect URL window.
STEP 24 Select Enable Redirect URL and specify a fully qualified domain name or IP address in the
Redirect URL field (including http://). If specified, guest network users are redirected to the
specified URL after authenticating.
STEP 25 Click Next. The Wizard displays the Summary - Confirm Your Settings window.
STEP 26 Review the settings that you configured. Click Back to reconfigure one or more settings. If
you click Cancel, all settings are returned to the previous or default values.
STEP 27 If they are correct, click Submit. Your WAP setup settings are saved and a confirmation
window appears.
STEP 28 Click Finish. The Login window appears to log in to the AP using the changed password.