Need help?Do you have a question about the Cisco WS-C2940-8TT-S and is the answer not in the manual?
Guide to initial switch setup using Express Setup or CLI.
Details the hardware capabilities of Catalyst 2940 switch models.
Describes the ports, LEDs, and Mode button on the switch front.
Details the port and slot numbering for Catalyst 2940 switches.
Details supported SFP modules, fiber-optic connections, and stipulations.
Describes the AC power connector and console port on the switch rear.
Overview of managing the switch: Network Assistant, Device Manager, CLI, etc.
Information and steps required before installing the switch.
Procedures for mounting the switch in various locations.
Instructions for connecting cables to an SFP module.
Steps to connect devices to 10/100 and 10/1000 ports via Ethernet.
Steps to connect the 100BASE-FX port to a device using fiber-optic cables.
Steps to connect fiber-optic cables to an SFP module port.
Interpreting Power-On Self-Test (POST) results and failure indicators.
Categorizes and provides solutions for common switch issues.
Methods for accessing the Command Line Interface (CLI) for switch setup.
Steps to access CLI through the console port connection.
Steps to connect the switch to an AC power source and outlet.
Steps to connect the switch console port to a PC using the adapter cable.
Instructions for starting terminal emulation software for switch communication.
Setting baud rate, data bits, stop bits, parity, and flow control.
Required network information (IP address, subnet mask, gateway) for switch setup.
Steps to set hostname, passwords, SNMP, and interface IP/subnet mask.
To Next Page
General