C-8
Catalyst 2940 Switch Hardware Installation Guide
OL-6157-01
Appendix C Configuring the Switch with the CLI-Based Setup Program
Where to Go Next
Where to Go Next
After you complete the setup program, the switch can run the default configuration that you created.
• For product overview information, see Chapter 1, “Overview.”
• For detailed installation procedures on mounting your switch on or under a desk or on a wall, or
connecting to the small form-factor pluggable (SFP) modules, see Chapter 2, “Installation.” To
complete this setup procedure, your PC must not be configured with a fixed IP address.
If you want to change the configuration or want to perform other management tasks, use one of
these tools:
• CLI
• Device manager from your browser (for one switch)
• Network Assistant (for one or more switches)
To use the CLI, enter commands at the Switch> prompt through the console port by using a
terminal-emulation program or through the network by using a telnet session. For configuration
information, see the switch software configuration guide or the switch command reference.
To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide.
To Next Page
Loading...
