Contents
iv
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
Supervisor Engine 2T 2-15
Primary Supervisor Engine 2T Components 2-17
Policy Feature Card 4 2-17
Multilayer Switch Feature Card 5 2-17
Features and Benefits details 2-17
Supervisor Engine 720 and Supervisor Engine 32 2-21
Front-Panel Controls (RSP720, RSP720-10GE, Sup720, Sup32) 2-21
Front-Panel LEDs (RSP720, RSP720-10GE, Sup720, Sup32) 2-22
Supervisor Engine 2 2-23
CHAPTER
3 Installing and Configuring Route Switch Processors and Supervisor Engines 3-1
Preparing for Installation or Removal 3-1
Safety Precautions for Module Installation and Removal 3-2
Preventing Electrostatic Discharge Damage 3-2
Tools Required for Module Installation 3-3
Determining Module Location 3-3
Installing a Supervisor Engine or Route Switch Processor 3-4
Removing a Supervisor Engine or Route Switch Processor 3-7
Hot Swapping (OIR) Modules 3-8
Removing and Replacing Memory 3-8
Connecting to the Console Port 3-9
Connecting a Terminal 3-9
Connecting a Modem 3-10
Connecting to the Uplink Ports 3-10
Using Flash Memory Cards 3-12
Installing a Flash Memory Card 3-13
Removing a Flash Memory Card 3-14
Power Management and Environmental Monitoring 3-14
Determining Software Feature Support 3-14
Upgrading DIMMs on RSP720 3-14
Configuring a Supervisor Engine or Route Switch Processor 3-17
CHAPTER
4 Troubleshooting Route Switch Processors and Supervisor Engines 4-1
Getting Started 4-1
AC and DC Power Supply Information 4-1
Chassis and Supervisor Slot Installation 4-2
To Next Page
Loading...
