Contents
v
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
RSP720-1GE Supported Hardware and Features 4-2
RSP720-1GE Unsupported Hardware and Features 4-2
RSP720-10GE Supported Chassis, Line Cards, and Modules 4-3
RSP720-10GE Unsupported Chassis, Modules and Features 4-3
Obtaining Technical Assistance 4-3
Troubleshooting Supervisor Failures 4-4
Troubleshooting Back-Plane Data Corruption During OIR of a RP 4-5
Troubleshooting Chassis Overheat Conditions 4-5
Troubleshooting Line Card Module 4-5
Troubleshooting Interface Down Issues 4-7
Traceback Decode Procedure 4-7
Troubleshooting Image Reload Issues 4-8
Troubleshooting Supervisor 2T 4-9
APPENDIX
A Technical Specifications A-1
Module Specifications A-1
Regulatory Standards Compliance A-1
APPENDIX
B Cable and Connector Specifications B-1
Supported Dense Wave Division Multiplexing (DWDM) Wavelength Optics B-2
Supported Coarse Wave Division Multiplexing (CWDM) Wavelength Optics B-4
Limiting Connection Distances B-5
Uplink Port Transceiver Modules B-5
1GE Uplink Ports and Cabling Specifications B-6
10GE Uplink Ports and Cabling Specifications B-8
GBIC Module Cabling Specifications B-9
Console Port Cabling Specifications and Pinouts B-10
Console Port Cabling Specifications B-10
Console Port Signals and Pinouts B-11
Identifying a Rollover Cable B-11
DB-9 Adapter (for Connecting to a PC) B-12
DB-25 Adapter (for Connecting to a Terminal) B-12
Modem Adapter B-13
Console Port Mode 2 Signaling and Pinouts (Sup2 Only) B-13
RJ-45 Connector B-14
Fiber-Optic Connectors B-16
To Next Page
Loading...
